MR.WET BELT

Ford Transit Connect wet belt replacement

Get my free quote →

On the Transit Connect, the wet belt engine is the 1.0 EcoBoost petrol of 2013 to 2022, which runs its cam belt and oil pump belt in oil. The guide figure for a belt change is now 10 years or 100,000 miles, whichever comes first. Send us the reg and postcode for a quote from an approved garage in your area.

Get my Connect quoteCheck my reg

What a full Transit Connect wet belt quote should cover

A petrol Connect has the same three-cylinder engine as the Fiesta, in a van that often works harder. A complete quote names each of these.

On the quoteWhy it's on a Connect quoteWhat makes it a bigger job
Cam belt and tensionerThe main belt in oil and the tensioner that holds itA seized tensioner may have to be cut free
Oil pump beltA second, narrower belt in the same oilNot every kit includes it, so it should be listed by name
Water pump and gasketThe pump is bolted through the timing cover and comes off anywayMany garages recommend a new one while it's off, to save paying for the same labour later, and they ask you first
Gaskets, seals and injector sealsThe crank seal, oil separator and cover gaskets, plus three injector seals because the fuel rail comes offReused seals are a common source of leaks after the job
Pulley bolt and friction discBoth are single use on this engineNone, provided the garage has the locking tools and torque multiplier
New accessory beltsThey come off for access and shouldn't be refittedA tensioner on the accessory side may also be worn
Oil, filter and coolantOil to Ford's specification, and a coolant refill after the water pump workBelt debris in the oil may mean the sump has to come off

When a Connect is due its belt

Ford first rated the 1.0 EcoBoost belt for 10 years or 150,000 miles, and a Connect is now due at 10 years or 100,000 miles. A van doing long daily rounds can reach that mileage within a few years.

The Connect's diesels are a different matter. The 1.5 and 1.6 TDCi and the 1.5 EcoBlue use a dry belt, and the 1.8 TDCi has a dry cam belt with only a small fuel pump belt in oil. The Caddy-based Connect from late 2021 is covered in the vans with wet belts list.

What the job involves on a Connect

  1. Fuel and electrics made safe. The battery is disconnected and the fuel pressure released, since the fuel rail has to come off.
  2. The front end cleared. The accessory belt, intake, catalytic converter, alternator, air conditioning compressor, starter and coolant pump are removed.
  3. Timing pinned. The crank and camshafts are locked, the vibration damper comes off and the old belts and tensioner are taken out.
  4. The new kit fitted. The oil pump belt goes on first, then the crank gear, tensioner and timing belt, with the cover and damper tightened in stages.
  5. Refilled and tested. Oil and coolant go back in to Ford's specification, and the van is started and road tested.

Like most vans, a Connect is usually off the road for one to two working days. Some garages can collect a van or do the work on site, so ask about it when the garage calls you.

Get my Connect quote

Signs a Connect belt is overdue

Small vans on multi-drop work clock up idling and short hops, which is hard on this belt. Book in if you see any of these.

  • An oil pressure light, even a brief flicker at a junction
  • A loss of power with a full load on board
  • An engine warning light with cam timing faults stored
  • Oil changes stretched to fit around your van's workload
  • A van with 100,000 miles or more and no belt change on its invoices

Help from Ford for Connect owners

Ford's free belt inspection programme was for the 2.0 EcoBlue Transit and Transit Custom, so it doesn't apply to the Connect. Any help with an early 1.0 EcoBoost failure goes through a Ford dealer and depends on a full service history, as our Ford recall advice explains.

Transit Connect wet belt questions

How much is a Transit Connect wet belt replacement?

That's down to the garage doing it, since each one in our network sets its own labour rate. It also depends on what the strip-down finds. Send your van's reg and you'll get a quote with every part listed.

How long will your van be off the road?

For most vans it's one to two working days. Ask for a slot that fits around your work when you accept the quote.

Is the Connect's oil pump belt included?

It should. The 1.0 EcoBoost has a small belt for the oil pump in the same oil as the cam belt, and both are changed in one go.

Is it worth doing the belt on an older Connect?

For a van that still earns its keep, it usually is. Next to a replacement engine, or another van, the belt job is the cheaper route by a long way.

Can the belt be done when the Connect is next serviced?

Usually, where the garage can, and it saves a second day off the road. It varies by garage, so ask about folding the oil service into the belt job when they call.

Request a quote for your Connect

Put the van's reg and postcode in below. The approved garage covering your area will quote for the full job and send it over before anything is booked.

Get my Connect quote