A wet belt change is a bigger job than a standard cambelt, because the belt lives inside the engine in oil. Here's what a specialist does at each stage, and what you should get back at the end.
Want to know what happens to your car while it's in? I'll walk you through it.
The wet belt change interval is set for each engine in years and miles, whichever comes first, and these are the usual guide figures.
Ford says a timing belt change can take up to eight hours on some of its cars, because so much of the front end has to come apart. A van or a larger engine adds its own extra steps.
Through our network, most jobs are booked within the same week. A car is usually back after one working day and a van after one to two, and the garage confirms the time with the quote. Some garages collect vans and fleet vehicles, and courtesy cars vary too, so ask about both when they call.
A proper wet belt change renews the parts that wear alongside the belt, as well as the belt itself.
The belt that keeps the crankshaft and camshafts in step, made for running in oil.
They hold the belt at the right tension, and an old tensioner can shorten the life of a new belt.
Fitted to engines like the 1.0 EcoBoost. It sits in the same oil and wears the same way.
Replaced with the belt on the 1.2 PureTech, because belt debris can block it and affect the brake servo.
Only fitted if the garage recommends it, usually where it shares the labour, and they'll explain why and ask you first.
Parts that can only be used once, like the crankshaft pulley bolt, are always new.
Any good specialist will be happy to answer these before you hand over the keys.
It can be done with the right tools and a workshop manual, but it's one of the least forgiving jobs on a modern engine. Each engine needs its own locking kit, several bolts are tightened in stages to an angle, and a timing error can wreck the engine on first start.
If you're not set up for that, a specialist is the safer route. Our guide to wet belt quotes explains what a full quote should cover, and you can see how a booking works step by step.
It depends on the engine, and whichever limit comes first applies. The 1.2 PureTech is due at 6 years or 62,000 miles, and the 2.0 EcoBlue in a Transit at 6 years or 100,000 miles. Send the reg with a quote request and the specialist will confirm the figure for your car.
Fresh oil of the right grade slows the wear, but it can't reverse it. A belt that's past its interval, or one that's already shedding debris, still needs replacing.
On engines that have one, yes. On the 1.0 EcoBoost it sits in the same oil and breaks down in the same way, so it's replaced in the same job.
It's a separate job, booked on its own because of the labour involved. A service on a 1.2 PureTech should still include a check of the belt's width through the oil filler.
If extra damage or debris turns up once the engine is open, the specialist stops and calls you with a revised quote. No extra work goes ahead until you've agreed to it.
Send the reg and postcode, and a local specialist will quote for the full job, with every part listed.