Every petrol Crossland X and Crossland has Vauxhall's 1.2 or 1.2 Turbo, the same PureTech engine as the Peugeot 2008, with its timing belt in oil. Most are now near or past the revised six-year interval. Enter the reg and postcode for a quote from an approved garage in your area.
Get my Crossland quoteCheck my reg
Got a Crossland? Send me the reg and I'll find a PureTech specialist for it.
The Vauxhall Crossland wet belt replacement cost depends on more than the belt kit. Check for these before choosing between quotes.
| On the quote | Why it's needed on a Crossland | What changes the size of the job |
|---|---|---|
| Belt, tensioner and idler roller | The full timing set for the 1.2, renewed together | Nothing extra if all three are quoted |
| New bolts and seals | The camshaft dephaser bolts and pulley bolt are single use, and the seals are disturbed during the job | Leaving them out invites leaks and slipped timing |
| Vacuum pump check | The pump runs the brake servo from the same oil as the belt | A pump with a blocked filter may need replacing, and the garage asks you first |
| Sump and strainer | Belt debris settles in the strainer | If the belt is swollen the sump comes off, and a strainer that's fully blocked means a new oil pump |
| Breather and solenoid filters | The crankcase breather duct and the valve timing solenoid filters can clog | Cleaning them adds time on a car run with a worn belt |
| Turbo oil pipe | Turbo engines only, the 110 and 130 | The non-turbo 81 and 83 PS cars skip this step |
| Oil to Vauxhall's specification | The right grade slows the fuel dilution that wears this belt | A sump full of thinned oil may point to other faults worth checking |
The revised PureTech schedule is 6 years or 100,000 km, 62,000 miles. Crossland X cars first went on sale in the UK in 2017, so every early example is already past the age limit.
The diesels are a separate engine family, and neither runs its belt in oil. The 1.6 Turbo D sold at launch has a dry cambelt, while the 1.5 Turbo D pairs a dry belt with a camshaft chain that's known to wear. Engine years are on the Crossland and Grandland engine page.
The belt swells as it wears, so the garage can measure it through the oil filler with a gauge and decide how far the job needs to go.
Access is through the front wheel arch once the wheel and liner are off, with the coils, intake pipes, oil separator and vacuum pump removed to reach the cover.
The intake and exhaust camshafts and the flywheel are pinned before the old belt comes out, so the new one goes on with the timing exactly right.
Most Crosslands are back after one working day, and most jobs are booked within the same week. The garage confirms the time and slot alongside its quote.
A worn PureTech belt can give very little away. These are worth acting on.
Vauxhall owners get the same Stellantis extended cover as Peugeot and Citroën owners, for qualifying belt-related oil pressure faults up to 10 years or 112,000 miles. We haven't found a UK safety recall for the Crossland's belt, and you can check yours by reg at gov.uk/check-vehicle-recall. The Vauxhall wet belt page sets out the conditions.
There's no single figure, because each garage charges its own rates and the work grows if the vacuum pump needs attention. Cleaning the strainer is part of every quote. The specialist covering your postcode quotes for the car, with every part listed.
Usually one working day. The garage can tell you more once it has gauged the belt, because a swollen one means extra work in the sump.
It should say. The vacuum pump shares the PureTech's oil, and belt debris can block its filter. A new pump only goes on if the garage recommends one, and it tells you why and asks first.
For a car that's otherwise in good order, yes. A PureTech that loses oil pressure can need a new engine, and on an early Crossland X that repair could be more than the car is worth.
Usually, where the garage can. The belt job already includes an oil and filter change, so booking them together saves paying for the oil twice, but it varies by garage, so ask when they call.
Send us the reg and postcode, and an approved garage covering that area will look at the job and come back with its quote. Before a garage gets any of our work, we check it follows the correct procedure.