MR.WET BELT

The 1.5 BlueHDi engine: belt, chain and what to check

Get my free quote →

Stellantis's 1.5 BlueHDi diesel doesn't have a wet belt, even though it often turns up on lists of them. Its known fault is the camshaft chain, and this page sets out how its timing works, which cars use it and what to do next. Not sure which engine is under your bonnet? Check it by reg.

How the 1.5 BlueHDi keeps its valves in time

The four-cylinder DV5 diesel uses two parts. A toothed belt at the front of the engine turns the camshafts from the crankshaft, and a short chain inside the cylinder head links the two camshafts together.

That belt runs dry, outside the engine oil. Parts makers sell it in a kit with the water pump, which the belt also turns.

Engine facts at a glance

ItemDetail
Engine familyDV5, four-cylinder diesel
Used byPeugeot, Citroën, DS and Vauxhall
TimingDry toothed belt from the crankshaft, plus a cam-to-cam chain in the head
Belt intervalGates lists 180,000 km (about 112,000 miles) or 10 years, but check the belt interval in your service schedule
Chain recall windowEngines built October 2017 to January 2023

Cars that use the 1.5 BlueHDi

  • Citroën C3, C4 and Berlingo diesels
  • Peugeot 208, 2008 and 308 diesels
  • Vauxhall Corsa and Combo diesels
  • Also the Peugeot 3008, 5008 and 508, the Citroën C5 Aircross and the Vauxhall Astra, Crossland, Grandland and Mokka

For other engines that keep the belt out of the oil, see our guide to cars without a wet belt.

The camshaft chain problem

Stellantis says some of these engines can wear the camshaft chain early, and that soot in the oil speeds it up. Its recall adds a software update and a noise test, then swaps in a wider 8mm chain if wear is found.

Special cover for chain faults now runs to 10 years or 150,000 miles from first registration, provided the car was serviced on schedule with oil to the approval in the handbook. Our Peugeot belt recall guide explains how this differs from the petrol belt schemes.

1.5 BlueHDi questions

Does the 1.5 BlueHDi have a wet belt?

No. Its timing belt is a conventional dry one, and the known wear is in the chain between the camshafts. The Stellantis engine with a belt in oil is the 1.2 PureTech petrol, covered in our PureTech wet belt guide.

What are the signs of a worn 1.5 BlueHDi chain?

Stellantis lists unusual noise or vibration. Gates adds a rattle on cold starts, hard starting, poorer fuel economy and an engine warning light, sometimes before 60,000 miles.

Not sure which engine your car has?

Send the registration with a quote request and the specialist will confirm if your car has a belt in oil at all. If it turns out to be a 1.2 PureTech petrol, the specialist can quote for the belt change.

Check my reg