MR.WET BELT

1.2 PureTech wet belt replacement

Get my free quote →

The 1.2 PureTech is Stellantis's three-cylinder petrol, and every version before the third-generation engine uses a timing belt running in oil. Here's how the interval has changed, which cars are affected and what a replacement involves.

Get my free quoteCheck my engine

Is the 1.2 PureTech a wet belt engine?

Yes, apart from the third-generation versions built from 2023. On earlier engines the timing belt sits inside the engine bathed in oil, so owners and garages call it a wet belt or a timing belt, and both mean the same part.

The PureTech's weak spot is fuel getting past the pistons and thinning the oil. The diluted oil attacks the belt, which swells, sheds debris and can block the oil pump strainer until oil pressure drops.

Which PureTech has a belt and which has a chain

EngineBuilt fromBelt or chain
1.0 and 1.2 PureTech, non-turbo2012Belt in oil
1.2 PureTech turbo2014Belt in oil
1.2 Hybrid (48V mild hybrid)2023Chain
1.2 PureTech 100 in the 2024 Citroën C32024Chain
Turbo 100 in the Peugeot 208 and 20082026Chain

Engines that use a belt and were built after June 2022 still appear in many models, reportedly with an updated belt. They aren't named in the published Stellantis cover, so a dealer can check your engine's build date by VIN and tell you what applies.

How the PureTech belt interval has changed

At launch the belt was rated for up to 10 years, and early handbooks printed a much longer mileage than today's. After a run of early failures, Stellantis cut the interval to 6 years or 100,000 km, which is 62,000 miles.

Many specialists now use the revised figure on older cars too, whatever the original service book says, so ask a dealer which interval applies to yours. On a car that mostly does short trips, where fuel dilution is worst, ask a specialist whether an earlier change makes sense.

Cars with the 1.2 PureTech wet belt

The version that uses a belt went into cars from five Stellantis brands.

Can you convert a 1.2 PureTech to a timing chain?

Stellantis hasn't published any way to fit a chain to an older engine. Its third-generation chain engines use a large share of new parts, and the Turbo 100 is around 70% new by value.

Aftermarket conversion kits for early 1.2 PureTech engines have been announced in Europe, sold only to garages from late 2026. They cost more than a standard belt change, and fitting one could affect any manufacturer cover. Ask the garage whether it fits them when it calls.

What a 1.2 PureTech timing belt replacement includes

Each specialist lists the parts in the quote, and these are the items it should cover. The full kit differs from one garage to another, so ask about anything missing when they call.

Belt and tensioner

A new belt and tensioner kit made for the PureTech, fitted with the engine locked in time using the correct tools.

Oil strainer check

The strainer is where belt debris collects. Every quote through our network includes a check and clean as standard, with the sump off if it's clogged, and the garage explains what it found.

Oil and filter

Oil to the exact specification printed in your handbook, plus a new filter. Check the quote names that specification, as a grade alone doesn't tell you enough.

How to make a PureTech belt last

A few habits slow down the oil dilution that wears the belt early.

  • Oil changes at least as often as the schedule says, and sooner if most trips are short
  • Only oil that meets the specification in your handbook
  • A longer run now and then, so the oil gets hot enough to burn off fuel
  • A look at the oil level every few weeks, since rising use is an early sign of trouble

What decides a 1.2 PureTech timing belt replacement cost

Each garage quotes at its own rates, and the total depends on the car the engine sits in and how much debris the old belt has left in the oil system. A quote that names the belt kit, the oil specification and any strainer work is the easiest to compare.

Before paying, check whether Stellantis's extended cover applies, because qualifying failures on engines built up to June 2022 can be covered for up to 10 years or 112,000 miles. The conditions are set out in our guide to Stellantis cover.

PureTech wet belt questions

Is the 1.2 PureTech a wet belt?

Yes, unless it's a third-generation engine. The hybrid versions from 2023 and the Turbo 100 from 2026 use a timing chain, while earlier 1.2 PureTech engines run their belt in oil.

How long does a 1.2 PureTech timing belt last?

The revised schedule says 6 years or 62,000 miles, whichever is sooner. Some belts wear out earlier, most often on cars used for short local journeys.

How much does a 1.2 PureTech wet belt replacement cost?

It depends on the garage, the car around the engine and the state of the oil strainer. The specialist quotes for your registration before work starts, and the quote should list the belt, tensioner and oil. What else goes in varies by garage, so ask when they ring.

Is it worth converting a PureTech to a chain?

For most owners, a belt change on schedule costs less. Conversion kits are new, sold only through garages and aren't a Stellantis part, so check what one would mean for any cover first.

Does the 1.0 PureTech have a wet belt too?

Yes. The non-turbo 1.0 PureTech went into the 2012-on Peugeot 208 and the second-generation Citroën C3, and Stellantis's belt cover includes it alongside the 1.2. The 1.0 in the 108, C1 and Aygo is a Toyota engine with a chain. More on the 1.0 PureTech engine.

Ask for a PureTech belt quote

Send the reg and postcode, and a PureTech specialist in your area will call you with a quote for the belt change.

Get my free quote