MR.WET BELT

Peugeot 2008 wet belt replacement

Get my free quote →

Does a Peugeot 2008 have a wet belt? Every petrol 2008 with the 1.2 PureTech, from the 2013 original until the chain engines arrived, runs its timing belt in oil. Send the reg and postcode for a quote from an approved garage, and check the Stellantis cover first if your car is under ten years old.

Get my 2008 quoteCheck my reg

PureTech 2008? Pass me the reg and I'll line up a garage that knows them well.

What a full 2008 wet belt quote should cover

PureTech quotes vary most on what happens beyond the belt itself. Look for these lines before comparing one garage with another.

On the quoteWhy it matters on a 2008Why some jobs take longer
Belt, tensioner and idlerThe belt in oil plus the rollers that guide and tension itNothing extra, as long as all three are renewed together
Single-use boltsThe camshaft dephaser bolts and crank pulley bolt are replaced, never reusedA quote that skips them is cutting a corner
SealsNew seals for the crank, oil separator, vacuum pump and timing coverLeaks from a reused seal mean the job has to be redone
Vacuum pumpIt powers the brake servo and sits in the same oil, so debris can block its filterA new pump is only fitted if the garage recommends one, and it explains why and asks you first
Oil pump strainerWhere loose belt material collects in the sumpA clogged strainer needs cleaning, and a fully blocked one means a new oil pump
Turbo oil feedDebris can lodge in the banjo bolt and pipe on turbo enginesCleaning adds time on the PureTech 110 and 130
Oil, filter and softwareOil to Peugeot's specification, plus the engine software update Stellantis issued for this engineSome garages can apply the update and others leave it to a Peugeot dealer, so ask when they call

The non-turbo PureTech 82 has fewer pipes to clear than the turbo versions, so it can be the shorter job of the two, though timings vary by garage.

When a 2008 is due its belt

The revised schedule for the 1.2 PureTech is 6 years or 100,000 km, 62,000 miles. On a 2008 doing under about 9,000 miles a year, belt makers also advise changing the oil every year.

Diesel 2008s are a different story. The 1.5 BlueHDi's known weak point is a camshaft chain rather than a belt in oil, and the Hybrid and the 2026 Turbo 100 both use a chain. More on the 208 and 2008 PureTech engine.

What the job involves on a 2008

The belt can be measured first

A PureTech belt swells as it wears. A specialist can check its width with a gauge through the oil filler, at three points as the engine turns, before deciding what the job needs.

Access through the wheel arch

The front wheel and arch liner come off, along with the coils, intake ducts, oil separator and vacuum pump, before the timing cover can be removed.

Camshafts and flywheel locked

Both camshafts and the flywheel are held with locking tools while the old belt comes out and the new one is tensioned.

Checks after the rebuild

The garage reads the fault history with a diagnostic tool and road tests the car before it goes back to you. Most 2008s are back on the road after one working day.

Signs a 2008 belt is overdue

PureTech belts often wear quietly, so these are reasons to get your car looked at soon.

  • A brake pedal that feels firmer than usual, since belt debris can starve the vacuum pump
  • Oil use between services, or the level dropping faster than it used to
  • An engine fault message or oil pressure warning on the dash
  • Mostly short trips, which let fuel build up in the oil
  • Six years since registration with no record of a belt change

Stellantis cover on the 2008

Since March 2024, Stellantis pays for qualifying oil pressure faults caused by early belt wear on PureTech engines built up to June 2022, for up to 10 years or 112,000 miles. The servicing conditions, and how to claim, are on our Peugeot recall page.

Peugeot 2008 wet belt questions

How much is a Peugeot 2008 wet belt replacement?

The Peugeot 2008 wet belt replacement cost depends on the garage's rates and on whether the vacuum pump or turbo feed need attention. The strainer check and clean is already included. The specialist covering your postcode quotes for the car, with each part listed.

How long does a 2008 belt change take?

Usually one working day, confirmed by the garage when it quotes. If the sump has to come off to clean the strainer, expect your car to be in for longer than a straight belt change.

Does the quote include the vacuum pump?

Only where it's needed. The pump sits in the engine oil, and if belt debris has blocked its filter the garage recommends a new one, explains why and checks with you before fitting it.

Is it worth replacing the belt on an older 2008?

On a first-generation 2008 that's otherwise healthy, yes. A failed PureTech can need a new engine, which on an older small SUV can be more than the car's value.

Can it be done at my next 2008 service?

Usually, where the garage can, and the oil is then only paid for once. It varies by garage, so ask when they call, and keep the invoice, because Stellantis looks at servicing records if you ever make a claim.

Get a quote for the belt on your 2008

Pop the reg and postcode in below, and a PureTech specialist covering that postcode will send a quote for the full job.

Get my 2008 quote